Rifatron MV-1648 Especificaciones descargar pdf (Pagina 58)

① Find and copy the upgrade file to the highest folder in the external storage device or portable storage

device supporting USB 2.0.

1) When copying an upgrade file from the PC, delete the USB device properly from

the PC and disconnect it from the USB port.

2) If the USB device is disconnected from the USB port while the upgrade file is

being copied, the DVR system may not automatically detect the file.

3) Upgrading is impossible if the HDD is not mounted.

Removing USB during the upgrade in progress may cause damage on the system.

② Connect the storage device with an upgrade file stored in the USB 2.0 port at Left/Right front panel..

③ Move to {Menu} Æ {Setup} Æ {System} Æ {6. Upgrade}

④ Select {Firmware} and the upgrade file list stored in the selected device and simple version information for

the selected file is then displayed as shown below.

[Figure 5-51. Firmware Upgrade File List Window]

⑤ After selecting the file to be upgrade and a window shown below appears.

[Figure 5-52. Firmware Upgrade Progressing Window]

※ Downgrading to a previous version is not supported.

※ It is recommended that the DVR ID should be the same as the remote controller ID.

※ The upgrade information window will then appear within 15 seconds.

⑥ Read the information and select {Yes} to start the upgrade gradually. Select {No} to return to {System}

mode.

⑦ After the update is completed, the system will be rebooted.

⑧ The system will automatically start. Upgrade is then completed.

⑨ Move to {Status} Æ {Product Information} Æ {Software Version} to check the version.

※All setup data are a fixed value in {Menu}Æ{Setup}Æ{System}Æ{6.

Upgrade}Æ{Setup}

1 2 ... 53 54 55 56 57 58 59 60

Sin comentarios

Rifatron MV-1648 Especificaciones Pagina 58