Rifatron MV-1648 Especificaciones descargar pdf (Pagina 11)

1. The input video type must be either NTSC or PAL; these two types must not be used

together.

2. Select the input video format (NTSC/PAL) using the CONFIG switch on the rear side of

the product.

3. Select the output monitor type (VGA/TV) using the CONFIG switch on the rear side of the

product.

4. CONFIG SWITCH

1) VGA Mode

Resolution of VGA Monitor is SXGA (1280*1024) and CCTV Monitor output is not

supported.

2) TV Mode

Resolution of VGA Monitor SVGA (800 * 600) and CCTV Monitor output is supported.

2-2-2. Connection of Other Devices

Difference between eSync M Series

ITEM

eSync M Series

1648 / 824 / 424

Loop Out OK

Spot Out OK

Audio Channel 4 / 2 / 1

Sensor Channel 16 / 8 / 4

Relay Channel [1ea NC/NO] [3ea TTL Out]

Connect the PTZ controller cable, audio input/output, network, and sensors as shown below.

Connected Device DVR Terminal

1 SPOT Monitor(CCTV Monitor) Rear SPOT

2 Mike / Speaker Rear Audio Input / Audio Output

3 LAN Cable Rear Ethernet

4 PTZ Camera Rear DIO (Digital Input/Output)

5 Sensor / Relay / TTL OUTPUT Rear DIO (Digital Input/Output)

6 Key controller Rear DIO (Digital Input/Output)

1) SPOT Monitor

Connect Spot Monitor to the rear SPOT terminal.

2) Audio Input / Output

eSync M Series supports [ 4 / 2 / 1 ] line input and 1 line output.

3) Terminal Block

[Figure 2-2. Terminal Block TB1]

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Sin comentarios

Rifatron MV-1648 Especificaciones Pagina 11